ExtremeSwitching (EXOS/Switch Engine) - Page 140 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

telnet: can't connect to remote host (10.1.0.252): No route to host

Hello;I am configuring 2 routers with VRRP, I have created vlan 1000 and I have passed it through the ports that connect them. By ping I arrive between them but I cannot make telnet from one to the other. What do I have to do to get it?This is my set...

Resolved! Is there a feature like Cisco Flex Links or Juniper RTG?

Hello,I would like to add an Extreme Networks X440-G2-12p-10GE4 Switch to my network.Now I want to know if there is a feature like Cisco Flex Links or Juniper RTG to connect this acccess switch to two aggregation switches:http://jozefklacko.blogspot....

Resolved! Normal Rx Power range for 10gb optics

Hello, Just put a new 3 switch stack of 5520’s in a site and I’m wondering if this one RX power is to be alarmed about. All ports below are 10gbps 850nm sm. See the one for port 2:59 has a * (star) next to RxPower. Is that bad? Indicative of just ...

Resolved! Error - The utilization of Host Entries hardware table on slot 1 has exceeded 90%

We see this error on our X440G2 stacks multiple times a day: <Noti:HAL.Card.L2L3HwTblThrshldExcd> The utilization of Host Entries hardware table on slot 1 has exceeded 90% It seem to correlate with very limited or no throughout on ports which have Wi...

Resolved! Time to live exceeded for a specific ip only

Hi All, Please help me to find out exact root cause of following caseI have recently install X440G2-48p-10G4 in our network with ExtremeXOS version 31.1.1.3 31.1.1.3-patch1-1 by release-manager, in fact all of our old switches are same model, configu...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN