ExtremeSwitching (EXOS/Switch Engine) - Page 175 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Removing OSPF routerid on VR-Default

Hi,I have a X460-G2 Switch which has 2 VRs configured on it and by mistake I configured a routerid on the VR-Default. Now, I am trying to remove the routerid from the VR-Default and leave only the VR-Production where it should be (this is the only VR...

Unable to configure switch from telnet

I’m trying to telnet into a switch stack to configure a few ports, but when I do I get a completely different CLI than I’m used to. Its only for one stack as well, any other of my closets I want to connect to in PuTTY works just fine. On the switches...

X440-G2 DAC compatibility with Intel 10 GbE X520-DA2 NIC

Has anyone attempted to use the Extreme 5m DAC SFPP cable (10306) with an Intel 10 GbE X520-DA2 NIC? Switchtype is X440G2-48p-10GE4 (16535), shoud work! Our customer needs to verify compatibility. Thanks, Udo

Resolved! 440-g2 suddenly lost connection to B5 via fiber connection same subnet

I’m having an issue with a fiber connection between a 440-g2 and a B5 switch in the same building. Everything was fine then the connection between the 2 were lost unexpectedly. All other devices plugged into the 440-g2 on vlan 1 works fine. After sev...

Help required for SNMP config in exos

For following cisco commands help me exos commands.snmp-server user netadmin Network v3 access 1snmp-server group Network v3 noauth access 1snmp-server group Network v3 priv read access access 1snmp-server group Tat@p0wEr@2017 v3 authsnmp-server vie...

Top Kudoed Authors

User

Count

28

25

20

20

17

GTM-P2G8KFN