ExtremeSwitching (EXOS/Switch Engine) - Page 179 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! easy way to remove lines of config

Hi, I am a Cisco CCNP that is learing Extreme. On Cisco I can take any command and put “no” in front of it to completely delete it from the config file. I have found that “unconfigure” and “disable” accomplish the same thing on extreme. The issue ...

TACACS or RADIUS client-ip

hi, I don't understand what the configuration of tacacs or radius asks, what has the client-ip been? Is it the switch that we want the accounts that are in RADIUS or TACACS to use? or what is it? thanks!

We recommend to disable MD5 and 96-bit MAC algorithms. we need do enable sha alogorithm

We recommend to disable MD5 and 96-bit MAC algorithms. we need do enable sha alogorithm

Printer's switch ports going down when printer enters power save mode

Hi! Since the introduction of switches lacking the capability of half duplex, we see that printers (and probably other stuff) lose the ethernet link when the printer enters power save mode. This means that a printer cannot be manages and no status ca...

Copy firmware to newly added member

I manage several school district networks. I have some x460’s being added to existing stacks in the very near future. Surly, the firmware will not be the same. I seem to remember a command/process to stack the new member into the stack, then copy ...

Top Kudoed Authors

User

Count

28

23

17

16

16

GTM-P2G8KFN