I have installed the 10G License on my X440G2-12p. I put a 1GB GBIC into port 14 and am trying to execute the following: # configure ports 14 auto off speed 100 duplex full Then I receive the following error: Error: Speed specified is not supported ...
Very similar to previously reported issues with fan speeds / temperature readings on 440-G2 models, however I’m running 30.6.1.11 which should have all these issues addressed. 3 switch stack of 440-G2-48p. After leaving them unplugged overnight for ...
I have some new, model 210 switches. I got them online but they are not passing DHCP or handing out addresses. If I manually config an IP and I get on from a client and ping the DHCP server. Any help would be appreciated.
