ExtremeSwitching (EXOS/Switch Engine) - Page 186 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

VDX-6740 I2C issue

Hi guys,I am facing this issue, it seems restored automatically, but I wanna know that kind of problem is it? [EM-1029], 1207989,, WARNING, VDX6740, Switch, a problem occurred accessing a device on the I2C bus (-4). Operational status (10) not change...

Extreme switch summit x460 Uplink Port Issue (SFP 10G-SR )

Hi Tech people i have 3 X460-G2-10G Extreme Switches in a ring topology. i am using Extreme 10G ShortRange SFP(850nm) module for interconnections between rings on front panel Port 51,52. The problem is that, the Ports are Stuck in Ready State. Phy...

How to create mirror port on X590

Good Morning, we replaced an Enterasys S4 with a pair of X590s. The customer configured on S4 an IDS ( Snort ) to monitor the vlans ( one port for each vlan ) with this command: set vlan interface 1 create set smon vlan create vtap.0.1 set port mi...

Resolved! MLAG configuration

Good evening, we are going to change an Exnterasys S4 with 2 x590 plus 4 v400. Now I have only one IP address configured. The question is whether the whole core can have a single IP address as if it were a chassis or should I consider them differe...

Resolved! Is it possible to create subinterfaces in different VRs on X670 going to the same trunk port?

I have read on this board: Extreme doesn't use sub interfaces. The closest equivalent would be adding the port to the vlan tagged. Ok, Juniper firewall with subinterfaces, e.g. ge-0/0/1.3 and ge-0/0/1.110, going via trunk to port 1 on an eXtreme X67...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN