ExtremeSwitching (EXOS/Switch Engine)
Questions and discussions about EXOS
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! Block SNMP traffic to devices

Hello all, I'm a bit of a exos newb and need assistance. Is there a way to create an ACL to specifically block SNMP traffic to a device connected to a port? I was thinking of using the GUI route and set up a dynamic ACL. Would this be a good idea or...

Resolved! EXOS 30.1.1.4

after upgrading EXOS firmware to 30.1.1.4, the ability to scan the cable disappeared * CoreSwichCanon.4 # run script cablediag.py -p 20 cablediag: 1.1.0.4 +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ + C...

Rate-limit

Hi everybody. I have two Summit x670 (15.4.1.3) switches and I'd like to limit inbound broadcast, multicast and unknown unicast packets on specific ports. So, I've configured rate-limit to 500pps. config port 3 rate-limit flood broadcast 500 config...

eyeV by New Contributor III
  • 255 Views
  • 23 replies
  • 1 kudos
GTM-P2G8KFN