ExtremeSwitching (EXOS/Switch Engine) - Page 226 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Disabling a separate port when a specific port drops

Have a requirement to disable a separate port if the primary port ( connected to a firewall ) goes down. I have a scenario where ih have two links to the internet from two separate X480 switches, I need to advise the ISP that the primary Firewall is...

Resolved! X460-G2 cpu type

Hello Hub, I need to know what exact type of CPU is used in Summit X460-G2 series.DataSheet states only it is 64-bit MIPS Processor, 1GHz clock.At least I have to know how many cores CPU has. BEST REGARDSRobert

Multicast within a VR environment, where the RP is on another VR .

I have a multiple VR sceanario where the routing is provided by an External Palo alto firewall.BAsic ospf etc works a treat.The RV point is within VR_default on the core and I have a stream coming from a vlan in VR servers , through 2 ospf connected...

Resolved! In EXOS how can I duplicate Cisco's switchport port-security mac-address sticky command?

We would like to lock down switchports on Exteme X450-G2's so nobody can move or connect their own equipment and obtain network access. We currently do this today with Cisco switches and the configuration is done on a port by port basis. Its very e...

Resolved! X440-G2-24x temperature

Hello, all! I understand that "The Summit G2 series of switches and others running EXOS 21.x (or higher) monitor CPU temperature instead of ambient temperature and therefore may show slightly higher temperatures than other models." But now I have X...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN