ExtremeSwitching (EXOS/Switch Engine) - Page 254 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Cisco aironet mobility express on EXOS switches

Hello, I'm trying to setup some Cisco Aironet 1832i in mobility express mode, so no WLC controller. I use an external DHCP server, but when i try to setup this on an x460 G2, impossible to get the access points to join the virtual controller, they...

Resolved! OSPF over GRE tunnel?

I was wondering if there is a way to do this all one one X450G2. Currently at one of our sites we needed to squeeze in an intermediate device, a Cisco 2901 router to terminate a GRE tunnel, and then from that 2901 router, establish OSPF adjacency to...

Resolved! EXOS: how to disable icmp redirect

on EOS i disable icmp redirect on a layer 3 interface this way: code:conf tint vlan.0.1000no ip redirectsexit How can i achieve that on EXOS ? Is there no cli command available ? Attaching a ACL on every L3 interface which discard icmp redirects ...

Windows 1903 802.1x issue

Hi, We have been upgrading our staff to Windows 1903 over the last few weeks. After the upgrade the users have trouble connecting to our wired network. We are using NAC and have three different levels of access. Unregistered - The user can only go...

Resolved! What's the extreme networks equivalent of Cisco's show interface command?

Hello, I'm wondering, is there an extreme networks equivalent to the Cisco command for show interfaces that gives you output results like this? Example: reliability 255/255, txload 36/255, rxload 8/255 Thank you

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN