ExtremeSwitching (EXOS/Switch Engine) - Page 26 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Problems with PTPv2 on X440G2

I have a problem with the synchronization of Unify base stations over the PTPv2 protocol on the X440-G2 switches. These stations synchronize with each other, one of them is the reference clock. Do these switches support PTP. I found information that ...

Doubts to configure redistribution

Hi all,It's my first time configuring an extreme network switch. I have a 5420f stack running EXOS. I have configured one VLAN with OSPF and the other Vlan with RIP.Now I would like to redistribute RIP into OSPF and OSPF into RIP. All route type. I w...

Resolved! Layer 3 VLAN design for Aggregation to Core Routing

I am new to Extreme, coming from the Cisco world. I have read that there are no "routed" ports on EXOS/Switch Engine but you create a vlan and assign only that vlan to the ports. I have a lab where I have 2 cores, 2 aggs, and 2 access layer switches....

Resolved! PA System Fixed By Turning OFF IGMP Snooping... Why?

Hello. This one had us stumped and in many cases, still does.For context, I am running 5420M-48W-4YE edge switches, and over the winter break (we are a k-12 school) I pushed a firmware update to my switches, bringing them to 3.6.1.5.Over the past few...

Resolved! Licensing of 5420

Good evening,I hope my message finds you well.We have acquired Extreme Networks switches 5420 series that came with ExtremeXOS and we want to migrate them to ExtemeVOSS.Our main concern is whether Extreme Networks licenses are linked to the serial n...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN