ExtremeSwitching (EXOS/Switch Engine) - Page 312 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Unable to use WinSCP to connect to XOS Switches anymore

Anyone else having trouble using WinSCP to connect to XOS switches? Unfortunately I haven't had to connect for some time, so I cant pinpoint when it stopped working. Windows 10 running WinSCP 5.13.4 (Build 8731) - checked Windows firewall - turned o...

Multicast not passing through two XOS Cores (670)

I have a network with two cores that were dual homed but we are upgrading and breaking legs so that only one leg from the edge is connected. PIM is enabled and two 10 gig ports are LAG between Core "A" and Core "B". If a device sending multicast on t...

Moving VLAN address definitions from Cisco To VSP - Retire Cisco - Error: Mulitnetting Not Supported

I am moving from Cisco to Extreme (VSP/ERS). I have a layer 2 connection between the Cisco core and the VPS "core". I have 5 VLANs (default gateways) defined on the Cisco and need to move them to the VSP. I remove the ip address from the Cisco (int...

EXOS SNMP access-profiles

Hi Community, There are many articles on the SNMP access-profiles; I have gone through few of them but could not find the answer to my specific queries.I have one snmp policy for "if match any" rules followinghttps://extremeportal.force.com/ExtrArtic...

Does X460-G2 need special config for snmp access?

Hi, We have a new building with one X460-G2 as core switch/router and many X440-G2 as edge switches. We started configuring and adding them to XMC. But X460-G2 does not come up in XMC. It does not respond to snmpwalk command also. We configure X440-...

Top Kudoed Authors

User

Count

28

23

17

16

16

GTM-P2G8KFN