ExtremeSwitching (EXOS/Switch Engine) - Page 328 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

MPLS route is still active in routing table even its corresponding OSPF route is not listed

Hi There, I found MPLS route is still active in routing table even its corresponding OSPF route is not listed in routing table. Ori Destination Gateway Mtr Flags VLAN Duration mp 192.17.80.55/32 172.17.79.1 ...

Configure a list of allowed mac addresses on a wifi vlan using Summit switches. xos 16.2.4.5-patch1-8

Configure a list of allowed mac addresses on a wifi vlan using Summit switches. I want to use our 460 core switch to allow a list of macaddreses on a single vlan and have not been able to build an acl.

Configuration file is not downloading in extreme switch when auto provision is enabled through dhcp

I have configured the dhcp server with option 43 code 101 with a script name "boot_file.xsf". After factory reset whenever the switch is contacting the dhcp server, it receives only ip address but not the boot_file.xsf file from the tftp server which...

OSPF and MPLS route

I have created OSPF,MPLS and VPLS in our switch. One of my core swith iproute to our remote network. i found one path ospf route to remote netowrk but the mpls show have tow path to remote netowk. You can see the below information. I really apperica...

Are there any effects at the network if i configure the MLAG LACP address later?

I want to configure the mlag lacp mac adresse in a productiv network. Are there any effects at the network? I will configure the mac of the mlag peer 1 as the mlag lacp mac address.

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN