ExtremeSwitching (EXOS/Switch Engine) - Page 329 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Multicast not passing through two XOS Cores (670)

I have a network with two cores that were dual homed but we are upgrading and breaking legs so that only one leg from the edge is connected. PIM is enabled and two 10 gig ports are LAG between Core "A" and Core "B". If a device sending multicast on t...

Moving VLAN address definitions from Cisco To VSP - Retire Cisco - Error: Mulitnetting Not Supported

I am moving from Cisco to Extreme (VSP/ERS). I have a layer 2 connection between the Cisco core and the VPS "core". I have 5 VLANs (default gateways) defined on the Cisco and need to move them to the VSP. I remove the ip address from the Cisco (int...

EXOS SNMP access-profiles

Hi Community, There are many articles on the SNMP access-profiles; I have gone through few of them but could not find the answer to my specific queries.I have one snmp policy for "if match any" rules followinghttps://extremeportal.force.com/ExtrArtic...

Does X460-G2 need special config for snmp access?

Hi, We have a new building with one X460-G2 as core switch/router and many X440-G2 as edge switches. We started configuring and adding them to XMC. But X460-G2 does not come up in XMC. It does not respond to snmpwalk command also. We configure X440-...

Lousy, stupid, stubborn old radiology devices (and the Summit stack that hates them)

Howdy folks, I am trying to finish up a job replacing some very old Cisco 3750's with a new stack of Extreme Summit 450-G2 switches running ExtremeXOS version 22.5.1.7. I have four devices left that are giving me problems. One of them will only con...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN