ExtremeSwitching (EXOS/Switch Engine) - Page 347 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Some ports don't link up

Hi, all! X440G2-48t-10G4 Upgraded to recommended EXOS 21.1.5.2 patch 1-2 Diagnostic is passing normal. In logs no any problems. But ports 8, 12, 38, 39, 45, 46 isn't go up when connect some device. Other ports normally working. Tried to del from d...

MPLS route is still active in routing table even its corresponding OSPF route is not listed

Hi There, I found MPLS route is still active in routing table even its corresponding OSPF route is not listed in routing table. Ori Destination Gateway Mtr Flags VLAN Duration mp 192.17.80.55/32 172.17.79.1 ...

Configure a list of allowed mac addresses on a wifi vlan using Summit switches. xos 16.2.4.5-patch1-8

Configure a list of allowed mac addresses on a wifi vlan using Summit switches. I want to use our 460 core switch to allow a list of macaddreses on a single vlan and have not been able to build an acl.

Configuration file is not downloading in extreme switch when auto provision is enabled through dhcp

I have configured the dhcp server with option 43 code 101 with a script name "boot_file.xsf". After factory reset whenever the switch is contacting the dhcp server, it receives only ip address but not the boot_file.xsf file from the tftp server which...

OSPF and MPLS route

I have created OSPF,MPLS and VPLS in our switch. One of my core swith iproute to our remote network. i found one path ospf route to remote netowrk but the mpls show have tow path to remote netowk. You can see the below information. I really apperica...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN