ExtremeSwitching (EXOS/Switch Engine) - Page 352 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

ELRP across multiple stacks

Hi, Have a scenario where we are using ELRP, which works great for disabling ports on the same stack but we have a stack in the same room and want to protect across the two - is this possible? My theory was that should an edge port see a ELRP PDU f...

Link aggregation (BD8810) will work with other vendor Netgear switch ?

Link aggregartion (BD8810) will work with other vendor Netgear switch ? I checked netgear it will support LAG I want the compatability whether both will work connect back to back through LAG ?

How to create the ACL Policy on Extreme X440-G2 Switch?

We have created 3 VLAN such as VLAN-1,2,3. Now, VLAN's should not communicate with each other they should be able to reach the only internet... How do we create the policy and map it appropriate VLAN Kindly help us to resolve the issue... ...

netlogin commands doesn't exist in command line on X440G2 v21.1.1.4

I'm configuring netlogin on a X440G2, and some commands aren't show in the CLI 1) the option "mode" dosn't exists configure netlogin ports 2:35 mode mac-based-vlans 2) the option "vlan" dosn't exists configure netlogin vlan NAC-EXTREME * Slot...

Export OSPF Cost 0 in EXOS 22.4.1

Hi, Why can I no longer export static routes into OSPF with a cost of 0 in EXOS 22.4.1? I need to be able to export the actual cost of the route as configured in the iproute command. Router-1 # enable ospf export static cost cost value ...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN