ExtremeSwitching (EXOS/Switch Engine) - Page 367 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Configure LAG ports for Cisco switch where "mode on" is forced

Hello all, I have a stack of four Cisco wireless controllers (model 4402). I need to get these moved from the Cisco switch they are presently plugged into, over to my new stack of Extreme Summit 450-G2 switches. The wireless controllers each have tw...

MLAG Peer Alternate IP: Controlling Which Switch Takes MLAG Ports Down?

Hi, MLAG on EXOS allows to configure an alternate IP address for the peer switch, see e.g. How to implement MLAG alternate peer ipaddress. This disables the MLAG ports of one of the two MLAG peers in case of an ISC failure, thus preventing problems ...

Warn:EPM.hello_rate EXOS21.1.3.7

Hi, after upgrading our X670G2 from 21.1.2.14 to 21.1.3.7 due to the SSH-problem (https://community.extremenetworks.com/extreme/topics/x670-g2-with-exos-21-1-2-14-establishing-ssh-se...) there are errors in the log, after establishing a ssh session:...

vrrp master change without known reason

Hi everybody, I have a problem with VRRP on my network. I have two x670 (both on version 15.5.3.4), I configure them for about 4 VRRP instances. The first one have a priority of 150 and a preempt delay of 180 sec. The second one have a priority of 1...

No IEEE 802.1AS Capable on Summit X440-24t switch

Dear Experts, I have a Summit X440-24t AVB switch with AVB enabled. I am connecting an AVB endpoint to the switch, which is running gPTP. The switch reports that the port is not "IEEE 802.1AS Capable" when I run the "show network-clock gptp" command...

Top Kudoed Authors

User

Count

27

18

16

16

12

GTM-P2G8KFN