ExtremeSwitching (EXOS/Switch Engine) - Page 389 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

x440 G2 route sharing

Hi I am looking at ECMP on a x440 G2 switch. The x440 is connected to two seperate routers and I would like to load balance traffic across them. The manuals indicate that it is supported on the x440 G2 but you can not configure the hashing. The x440...

802.1x authentication

Hi Team, I need to configure the 802.1X authentication in Summit X440 -24p-10g switch. I have NPS server in our environment . Server details :- Ip address 192.168.1.74 Subnet :- 255.255.255.0 Gateway :- 192.168.1.1 Sw...

configure rule ELRP not in the configration

When I configure ELRP on a x440-G2-24P-10GE with firmware 22.4.1.4 like: enable elrp-client configure elrp-client periodic Default ports interval 1 log-and-trap disable-port permanent. And I do a sh conf ELRP, I see: configure elrp-client perio...

Using SNMP, how can I find the VLANs associated with an interface

Using SNMP, how can I find the VLANs associated with an interface? I know I can snmpwalk code:1.3.6.1.4.1.1916.1.4.17.1.1 but that only starts "at the top" (ie the first port), and takes AGES to get to the actual interface I'm interested in... Than...

XOS - clipaging

Hi, is there a way to disable clipaging on XOS-based switches permanently? The command 'disable clipaging'only effects the active ssh/telnet session. Thanks in advance Philipp

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN