ExtremeSwitching (EXOS/Switch Engine) - Page 390 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Trunk with DHCP for access point

Hi, I've a problem with my access point with my switches, i use Meraki platform for control WIFI. Normally i plug access point in my switches and i tag port but if i tag port access point don't have IP by my DHCP and are offline on my platform. If i...

DIAGNOSTIC FAIL: run test loopback eth iterations 50 pps-rate fast

ERROR: Timeout waiting on Rx Pkt [ifnum=0, ms=2000] ERROR: Receiving Pkt [ifnum=0, Iteration=1, Length=64] DIAGNOSTIC FAIL: run test loopback eth iterations 50 pps-rate fast

X440-G2-48p Stacking 10Gbe links, license error on slot2

Ok so I might have shot myself in the foot here but figured I post to ask... I have a stack of three X440-G2-48p switches, and prior to stacking I foolishly installed the 10GBe license on Slot 1 and Slot 3 as we were going to use 10Gbe uplinks (now ...

Two extreme switch can ping each other

Good day all I have been looking around if this has been ask and answer it seems I can’t find any. I have a problem with two extreme switch they can’t ping each other I have confing truck port 48 to connect each other but when I plung my l...

New Vlan on our main switch but cannot use any of the IP addresses in that Vlan

I have created a new Vlan on our main switch and can ping the Vlan's gateway from all areas but if we try to use an IP address from that Vlan it will not work. Any ideas on what needs to be fixed?

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN