I am trying to setup telnet and ssh access on my extreme swicthes i ahve already tried the suggested solutions but they do not seem to help
here is my configuration
X440G2-48p-10G4.1 # sh configuration
# Module devmgr configuration.
how to translate these commands from Enterasys to Extreme 460?
i haven't found the right command and no port on this so far.
ip forward-protocol udp 2009
ip forward-protocol udp 3001
thanks in advance
Had an case 01280313 with X620 error messages.
May be it can be usefull to add to GTAC knowledge base.
Below error messages often appear
IPv4 multicast entry not added. Hardware Group Table full.
debug hal show ipv4mc
We have a X450-G2 with 184.108.40.206.
This switch is the router of a branch. Unfortunately the router-transfer nentwork is not part of VPN IPSec SA. So we have several problems with services which using the route-based source interface to reach some ser...