Added a new exos switch to one of my sites, remoting into to do initial configuration, I seem to be getting stuck on the IQagent staying in a disabled state, I already specified which virtual router to use to connect to XIQ, is there a command I need...
Hello!I have to configure LLDP-MED in a 4220 and the command is not allowed by the CLI:Enable lldp port allconfigure lldp port all advertise vendor-specific med capabilitiesconfigure lldp port all advertise vendor-specific med power-via-mdiconfigure ...
Suggest a latest firmware for Extreme 3626GTS
Only one cisco AIR-CAP2702I-K-K9 is connected to port 23Currently, when log and show inline-power info port 23, the state goes back and forth to disable/deliveryThe problem is 1. Currently, users are using it without any problems2. port 1-22 까지 disab...
Hello all,I'm pretty new to configures Extreme switches (5320 in my case).At this moment, I have done the following setup.I have 4 floors, each with a stack (1 with 3 switches and 3 with 4 switches. U1-U2 ports are connected in a ring)What is the bes...
