ExtremeSwitching (EXOS/Switch Engine) - Page 405 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Joining Switches via OSPF, with LAGs / MLAG, Configuration Best Practice

Hi, Just creating a configuration and wondered what would be deemed the proper way to do it. I'm currently joining a legacy network with a new Extreme network, and would like to do it over layer 3 using ospf. The legacy core network is a stack, an...

Proper way of adding another private vlan

Hi, Switch: X670 , 16.1.3.6-patch1-9 Existing configuration looks like this: create vlan vlan10 tag 10 create vlan net_pvlan1 tag 2 create vlan sub_pvlan1 tag 3 create private-vlan pvlan1 configure private-vlan pvlan1 add network net_pvlan1 config...

Stacking cable support for X440-G2 (correction to documentation)

In the Summit Hardware Installation Guide for EXOS 21, the "Stacking Cables" table is incorrect with respect to stacking-cable support on the X440-G2 switch. http://documentation.extremenetworks.com/summit/Summit_Family_HW_Install/Stacking/r_stacking...

MLAG ISC passing through Core Switch

Hello, I have to to create an MLAG on two switches for a server but there are no free ports available for ISC. Is it possible to use the uplink ports connected to core switch for ISC vlan tagging ? Or is it necessary to have a dedicated ISC link bet...

TCL Script to read from line and input in another line

what i am trying to automate is simple, but i have little knowledge about TCL. 1- issue the following command: show configuration netlogin. 2- match the underlined part from the below output of the previous command: * Slot-1 # sh conf "netlogin...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN