ExtremeSwitching (EXOS/Switch Engine) - Page 406 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Installing 2 XGM3-2SF modules in a active stack

Hello, I have a stack consisting of (2) X460-48p switches. We have purchased (2) XGM3S-2SF modules to run 10GB SFP+ connections from each switch to add to a fiber ring. Can I install these modules without powering down the stack? Thanks!

IP static route limits for EXOS

I need to know what is exact limits for IPv4 static routes and IPv6 static routes in EXOS. In EXOS 22.2 release notes (Limits section, page 34) there are IP multicast static routes oraz IP unicast static routes entries, both limits are equal to 1024....

Joining Switches via OSPF, with LAGs / MLAG, Configuration Best Practice

Hi, Just creating a configuration and wondered what would be deemed the proper way to do it. I'm currently joining a legacy network with a new Extreme network, and would like to do it over layer 3 using ospf. The legacy core network is a stack, an...

Proper way of adding another private vlan

Hi, Switch: X670 , 16.1.3.6-patch1-9 Existing configuration looks like this: create vlan vlan10 tag 10 create vlan net_pvlan1 tag 2 create vlan sub_pvlan1 tag 3 create private-vlan pvlan1 configure private-vlan pvlan1 add network net_pvlan1 config...

Stacking cable support for X440-G2 (correction to documentation)

In the Summit Hardware Installation Guide for EXOS 21, the "Stacking Cables" table is incorrect with respect to stacking-cable support on the X440-G2 switch. http://documentation.extremenetworks.com/summit/Summit_Family_HW_Install/Stacking/r_stacking...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN