ExtremeSwitching (EXOS/Switch Engine) - Page 433 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

ELRP per vlan - is that possible?

XOS firmware Port configured as trunk and have some vlans tagged ELRP in case of loop in one of the vlans, disables a link on a port Is there any way of disabling a specific vlan, on which the loop is caused, instead of disabling the port? BTW, EAS ...

IPV6 broadcast storm, on an IPV4 network

We have a number of printers that by default have IPV6 configured though not used. ( not supported by me ) These printers are also connected to an IPV4 vlan where the IP address is allocated via DHCP and routed at a distribution switch X460. Recen...

Simulate a POE "Failed" state?

We are testing some network monitoring rules, and would like to generate events/alarms when a port delivering POE transitions into the 'faulted' state. Is there a way, preferably in software, to simulate a port experiencing a POE fault state?? We wan...

x440-8p with two lg tv connected. somtimes TV has no video only channel, or audio only. worst the TV freeze.

i have x440-8p with two lg tv connected. somtimes TV has no video only channel, or audio only. worst the TV freeze. but if you will check the port statistics rx / tx are coming.

explanation on the switch sw configuration

Hi All, I am new to the extreme switch configuration. Can u pls help in understanding the sh switch command , Current State: OPERATIONAL Image Selected: primary Image Booted: primary Primary v...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN