ExtremeSwitching (EXOS/Switch Engine) - Page 435 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

EXOS: OSPF "passive-interface default" needed

Currently i configure OSPF on X870 Switches (recent EXOS 22.2.x). I am looking for a command for setting all vlan to "passive default" like i do it on EOS or Cisco. Currently i do manually vlan for vlan only. configure ospf add vlan VLAN-0111 a...

Extreme switch disconnects frequently from ODL controller

Hi, I'm using this switch X460G2-48p-10G4 (Stack) with openflow mode enabled and connected to my opendaylight controller as "primary": Controller : Primary Status : ACTIVE Datapath ID : 00000204969ac040 VR : VR-Def...

Alternative method to using IP Forwarding?

We have an Extreme switch that has the following vlans. vlan1 switch interface is 192.168.10.4/24 vlan2 switch interface is 192.168.50.240/22 (so hosts are 48.0 through 51.255) vlan1 has ipforwarding enabled but vlan2 does not. We need hosts...

Initial setup on X440-g2-24p Can't ping between devices with static ip's on ports 2 and 3 (or any others)

Initial setup, Out of Box configuration... Using the default VLAN, I can't ping between two statically set ips on devices attached to ports 2 and 3. (or any other two ports) I have: configure vlan default add ports 1-28 configure vlan default ipaddr...

Not able to see Cookie Id on a Packet In on Extreme x440

We are running few VLANs in Hybrid mode (openflow enabled). But in the packet in that we get we are not able to see the cookie id. Cookie Id is 0x00000000000000 Match field is just contains the port number We were expecting the cookie id to match t...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN