How to delete the .xos installed image from extreme switch on 16.x.x.x.
How to delete the .xos installed image from extreme switch on 16.x.x.x.
How to delete the .xos installed image from extreme switch on 16.x.x.x.
Hi Guys I am trying to setup telnet and ssh access on my extreme swicthes i ahve already tried the suggested solutions but they do not seem to help here is my configuration X440G2-48p-10G4.1 # sh configuration # # Module devmgr configuration. #...
Hello Guy, how to translate these commands from Enterasys to Extreme 460? i haven't found the right command and no port on this so far. ip forward-protocol udp 2009 ip forward-protocol udp 3001 thanks in advance
Hello, all! Had an case 01280313 with X620 error messages. May be it can be usefull to add to GTAC knowledge base. Objective: Below error messages often appear IPv4 multicast entry not added. Hardware Group Table full. But debug hal show ipv4mc ...
We have a X450-G2 with 16.1.3.6. This switch is the router of a branch. Unfortunately the router-transfer nentwork is not part of VPN IPSec SA. So we have several problems with services which using the route-based source interface to reach some ser...
User | Count |
---|---|
28 | |
26 | |
19 | |
18 | |
17 |