ExtremeSwitching (EXOS/Switch Engine) - Page 453 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

CIFS SMB network configuration

CIFS ( common internet file system ) file transfer system /SMB Trying to understand how this protocol works . I have a few servers which use CIFS , when on the same network , through a few switches ,|X670 etc. when connected locally on the same swi...

Multicast Protection

We run TV Stations throughout our network via multicast(sparse) with networks at each local router that talk to end devices. We run OSPF for communication throughout our network and we have multiple RP's that these end devices can request channels fr...

Extreme using radius JUST to authenticate, not for all command verification.

I have a ExtremeXOS version 16.2.1.6 configured. My intention ware just authenticate my users, but I realized when a user pass any command the Extreme checks the permition. Is this normal? It is possible change this behavior? If yes how? Best regards

ELRP per vlan - is that possible?

XOS firmware Port configured as trunk and have some vlans tagged ELRP in case of loop in one of the vlans, disables a link on a port Is there any way of disabling a specific vlan, on which the loop is caused, instead of disabling the port? BTW, EAS ...

IPV6 broadcast storm, on an IPV4 network

We have a number of printers that by default have IPV6 configured though not used. ( not supported by me ) These printers are also connected to an IPV4 vlan where the IP address is allocated via DHCP and routed at a distribution switch X460. Recen...

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN