ExtremeSwitching (EXOS/Switch Engine) - Page 484 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Config saves after 'reboot', not after power loss

We have a switch (Summit X440-24t) whose config appears to revert back to factory default whenever it experiences an abrupt power loss. After a power loss, logging in with 'admin' user prompts the user with the canned preset messages (disable telnet...

Creating a gateway between VLAN and MPLS over GRE with x670v

We're trying to set up a x670v as a gateway between a VLAN net and a MPLS over GRE net. Seems the x670v supports all required technologies. Does anyone have any input/example config for how it can be done?

EXOS Identity Management - MIBs

Hi, Does anyone use MIBs to extract Identity Management data from EXOS switches? I've found the OID 'ExtremeLocationInetAddrEntry' which shows port, mac address & IP address of the 'identity-management entries'. (MIB 16.1.4.2) But crazily, there'...

X440-48p wont boot

My switch wont boot. After plugin in console all i got one screen is this: Extreme Networks Alternate BootStrap Image And nothing comes after that. MGMT light is blinking fast all the time and wont stop.

Having problems setting ports to 10mb after XOS 22.2.1.5 upgrade

Hello all, I just sent out the new XOS 22.2.1.5 firmware to a few switches now i am having issues setting ports to 10mb for some legacy devices. UPS cards and old cisco pots ata's. I did not have this issue on the previous FW XOS 22.1.1.5. I only ...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN