ExtremeSwitching (EXOS/Switch Engine) - Page 498 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

EXOS VM absorbing ERPS packets causing other switch to stay in Pending ERPS state

After a lot of unsuccessful tries to build a VM lab with 5 switches in EAPS ring and other 2 in a ERPS subring of the main ring, I started to capture packets in VirtualBox and found out that the switches are absorbing the R-APS packets instead of for...

May I connect with SSH2 or telnet to the decicated MGMT-port (VR-Mgmt VLAN)?

Hello, team! I've configured IPs for MGMT-ports of all my Exteme switches and connected them to dedicated 2960. Ping works fine but I am unable to connect to the switches with SSH or telnet. Is it possible? Thanks!

ACL for blocking none valid dhcp requests

Hi! Is it possible to block relayed DHCP request that doesn't contain a specific option60 or a specific range of customers source mac-adress (inbedded in the DHCP request, not source mac because the requests are relayed) in a ACL? With regards Mat...

dhcp-snooping trusted servers

Hi all, I am just looking at using extreme as edge switches, have been using them for core and aggregation for years. We have a large network with two central DHCP servers which we then use UDP forwarding from each user vlan. As I see it, we need ...

Is there a way to stack two commands in a single line via the CLI (like dis port then en port)?

Wondering if there is a way to stack two commands in a single line of the EXOS CLI? For example in windows you can issue a "ipconfig /release & ipconfig /renew" in one line and it will execute both commands back to back. I need to cycle a port than...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN