ExtremeSwitching (EXOS/Switch Engine) - Page 526 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

EAPS Shared-port 31 - Seg ment 7 - Seg-timer-failed-flag is Cleared domain:VSM_EAPS2

11/18/2016 10:50:39.04 EAPS Shared-port 31 - Seg ment 7 - Seg-timer-failed-flag is Cleared domain:VSM_EAPS2 11/18/2016 10:50:38.95 EAPS Shared-port 31 - Seg ment 7 - Seg-timer-failed-flag is Set domain:VSM_EAPS2 What does this ac...

IPv6 BGP network advertisement

Hi Experts Getting error while trying to advertise IPv6 routes in BGP peering. IPv4 works fine, but getting error in IPv6. The below network is preset in IPv6 routing table and shows as being directly connected. (vr Test) SwitchA # configure b...

MPLS Kernel error 16.1.3.6

VPLS VPN not working. After disabling see errorMPLS gport resolve failed for unit = 0 vpn = 0x70e3, port = 0xffffffff vp = 0x18000a0c, rv = -7 (Entry not found)08/30/2016 11:37:25.99extreme_mpls_del_vp_nh_xref: MPLS ECMP NH vp : 0xa0c l3intf = 0x83f ...

Is there a command to check the incoming DSCP value entering the switch?

Any command to check the incoming DSCP value entering the switch in ExtremeXOS version 16.1.3.6?

Tracking L2VPN state change

Hello everybody, I want to know a way to log the l2vpn peer state changes on my switch, is that possible? By using this MPLS.L2VPN.ChgPWState, am I going to see both vpls and vpws changes? Thanks!

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN