ExtremeSwitching (EXOS/Switch Engine) - Page 547 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Extreme L3 switch doesn't send icmp redirect packet.

In the network there are a L3 Extreme Networks switch and a Cisco wan router. Both devices operate with OSPF. The pc has a default gateway, which is the L3 switch. When I connect to a device which is connected through the cisco router, I expect ...

MLAG versus Stack

I was going through the definitions of MLAG support on Extreme Switches (670, BD8000 & BDX8) and link aggregation on stacked switches (All summit) and wondering to understand the difference between these two. If I am proposing X460 in a place where c...

How to determine the number of ports using the switch model number ?

I have a remote Summit X460G2-24x-10G4 stack with 2 modules. My question is, how to determine the number of ports using the switch model in a module? show ports returns 34 ports for each slots.

LAG Questions

Hi! I want create a LAG configuration, but i have some questions. 1. can i configure it using ports to diferent slots? 2. once configured if the master port pass to down state , everything LAG link is down? Regards

UPM makes the switch crash / lag horribly

Hello, I have been working lately on UPM testing for later use. I noticed something pretty strange, when I execute a very simple script, after 2-3 times, it makes the switch lag horribly and everything slows down. The switch itself still does it's j...

Top Kudoed Authors

User

Count

28

26

19

19

17

GTM-P2G8KFN