Hello i have two switch one x440 other x460 and cant ping hosts under another switch with diffret subnet. How to configure switches to make communication possible? Or do i need to make static routing? SW1 Config Bud_1-X460.44 # show config # # Mo...
Hi, during configuration of my Summit X460 and X440 switches I've encounter a problem with VLAN communication between switches. Topology: comp1 ==(port23) SW1 (port1)==(port24) SW2 (port1)==(port1) SW3 (port2)== comp2 The objective is to communicate...
H! Is there any plays to support x460-g2 ? // Andreas
Have seen this before in a similar setup, but have another situation where on 'show ports congestion' I am seeing packet drops. rx and tx flow control has been disabled on all ports. Each ports is configured for Data and Voice, with PC's hanging of...
I have a macbook air that uses a thunderbolt ethernet adaptor. Even on a switchport that works fine for a desktop PC, when I plug my macbook into my summit 460 G2 running XOS 16 I see the interface light for about 3 seconds, then the interface goes ...
