ExtremeSwitching (EXOS/Switch Engine) - Page 635 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

X450e to 2960S

I have a X450e that I am linking a Cisco 2960S too. Both ports are in VLAN 99 (management). They are not able to talk to each other and I am not able to access the Cisco switch by the IP assigned to VLAN 99. Cisco Config interface GigabitEthernet1/...

XOS upgrade on MLAG peers

Hi everybody. Does any recomendation about upgrading XOS on MLAG peers? Should I disable ISC link between peers or it just an ordinary upgrade like download/install/reboot?

Network Load Balancing in summit X460-24x

Device: Summit X460-24x ExtremeXOS version 15.4.1.3 NLB configuration. It is being made to integrate a VMware virtualized system which used Network Load Balance, I use LACP main ports of group 1: 2 to 1:12 enable sharing 1:2 grouping 1:2, 1:4, 1:6,...

Configure edge-safeguard and bpdu-restrict only on CIST for MSTP?

Have an example MSTP configuration below. My questions is do I need to enable edge-safeguard and bpdu-restrict on each of the edge ports in all the STP domains or just the CIST (S0) as per below, and would this make any difference if the edge devic...

Resolved! EXOS 15.3.4.6 EOS

Dears, I would like to know when is the End of support for the EXOS 15.3.4.6 and EXOS 15.3.5.2? end where can I get the official End of support list for all software release. I have a summit X450a-48t. appropriate your support Sal

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN