ExtremeSwitching (EXOS/Switch Engine) - Page 636 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Network Load Balancing in summit X460-24x

Device: Summit X460-24x ExtremeXOS version 15.4.1.3 NLB configuration. It is being made to integrate a VMware virtualized system which used Network Load Balance, I use LACP main ports of group 1: 2 to 1:12 enable sharing 1:2 grouping 1:2, 1:4, 1:6,...

Configure edge-safeguard and bpdu-restrict only on CIST for MSTP?

Have an example MSTP configuration below. My questions is do I need to enable edge-safeguard and bpdu-restrict on each of the edge ports in all the STP domains or just the CIST (S0) as per below, and would this make any difference if the edge devic...

Resolved! EXOS 15.3.4.6 EOS

Dears, I would like to know when is the End of support for the EXOS 15.3.4.6 and EXOS 15.3.5.2? end where can I get the official End of support list for all software release. I have a summit X450a-48t. appropriate your support Sal

dhcp snooping

Hello! When configure L2 dhcp relay (dhcp snooping+trusted server), do I need also #enable bootprelay? Thank you!

ELRP on protocol IP

Hello, Im looking for sollution for loop protection on xos, and i found ELRP. But it doesnt work on vlan configured as protocol ip, as i have on my company. I found two solutions, but im not sure is the first one safe? 1. Adding snap 0x00bb to pr...

Top Kudoed Authors

User

Count

33

29

22

20

17

GTM-P2G8KFN