ExtremeSwitching (EXOS/Switch Engine) - Page 637 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Virtual XOS killing ESX host CPU

After initial install and configuration of the vSummit, VM stays at around 60-100Mhz host CPU usage but after about 3min sitting idle, CPU utilization jumps to 3GHz+ and in many cases maxes out Host CPU resources. Extreme VM performance becomes slug...

Hitless upgrade on BDX8

Can we do hitless upgrade on BDX8? Please share any reference document

460-G2 10gig vim won't run 1gig??

We just completed an install of 460-G2s mostly the 10g version. On multipule switches we found we were not able to get 1gig links to come up on the 10gig vim modules. We are running code summitX-15.6.2.12-patch1-1.xos The intent was to bring the st...

ACL installation problem on x670 - XOS 15.5.3.4

Hi,I'm facing a problem with two X670-48x in version 15.5.3.4 when I try to install an ACL on an egress port.Here is the content of the policy file : entry NO-DHCP-SR1-SR2-01 {if match all {vlan-id 443 ;protocol udp ;destination-port bootps ;ethernet...

Switch X460G2 - eee set enable error

tHi, I have an problem with an X460-G2-48p switch witch gives the following erors on 8 ports. The ports where working fine until a few days ago, now they dont come up annymore. 2015-06-24 17:21:54.73 Slot-2: bcm_custom_extr_eee_config_set(16711): ...

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN