ExtremeSwitching (EXOS/Switch Engine) - Page 638 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

460-G2 10gig vim won't run 1gig??

We just completed an install of 460-G2s mostly the 10g version. On multipule switches we found we were not able to get 1gig links to come up on the 10gig vim modules. We are running code summitX-15.6.2.12-patch1-1.xos The intent was to bring the st...

ACL installation problem on x670 - XOS 15.5.3.4

Hi,I'm facing a problem with two X670-48x in version 15.5.3.4 when I try to install an ACL on an egress port.Here is the content of the policy file : entry NO-DHCP-SR1-SR2-01 {if match all {vlan-id 443 ;protocol udp ;destination-port bootps ;ethernet...

Switch X460G2 - eee set enable error

tHi, I have an problem with an X460-G2-48p switch witch gives the following erors on 8 ports. The ports where working fine until a few days ago, now they dont come up annymore. 2015-06-24 17:21:54.73 Slot-2: bcm_custom_extr_eee_config_set(16711): ...

Vlan Graphing

Hi All, We have just replaced a few Cisco Switches with Extreme Switches, with the Cisco switches we could graph each vlan on the switch. I just would like to understand if this is possible with Extreme, we have configure ports x:xx monitor vlan yyy...

Configure stpd for inter switch links

Hello I need to setup a basic stp domain using an X670 (EXOS 15.2) to enable fast failover between the primary link - a 10G fibre connection, and a secondary link - a 100M wireless link. Obviously the preferred service is the 10G fibre. Both link...

Top Kudoed Authors

User

Count

33

29

22

20

17

GTM-P2G8KFN