ExtremeSwitching (EXOS/Switch Engine) - Page 661 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

AVB over Fiber

Hello. I have 2 x Summit X440-24P switches with a 10053-PRO installed in each and connected to fiber. One switch has 3 x AVB devices connected. The other switch had 1 x AVB device connected. Both devices have AVB enabled on all ports. I can ping devi...

Any way to perform probing on a logical address to drive a route change?

Good afternoon. I have a client who just installed a 1GB L2 connection between two offices. The firewall which routes between sites cannot keep up with the rate of the circuit so we want to make the switch the default gateway on each end and use it...

Is Fibre Channel Over Ethernet supported on extreme Summit Switches , if it is how is it configured.

I am looking to confirm that extreme hardware ( Summit Xseries )support FCoE. If so what is it called in "Extreme speak " and how specifically is it configured,.

STP mode or default, whats the difference?

Hi there, Working on a site that has adopted an odd configuration for spanning-tree that I'm trying to make sense of. The below is an edited example taken from an edge switch. The network consists of all extreme devices. Its seems as though PVST+ h...

Summit Stack bcmDPC high cpu utilization

I have a stack of Summit 450 and 460 switches. All are running XOS 12.6.2.10 (I know it's old, but we don't pay support so can't upgrade). We regularly have a situation where the management interface (SSH or Telnet) is slow to respond. Traffic doe...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN