ExtremeSwitching (EXOS/Switch Engine) - Page 669 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Black Diamond 8810; what is the command to show the layer 3 (inter vlan) switching utilization?

Hello. I want to know in a Black Diamond 8810 the Utilization of the Layer 3 traffic between the Vlan's. For the Physical interfaces the command to see the utilization is "show ports utilization". Is there also a command to see the same for the Vl...

SNMP trap with sysName parameter

I want to receive traps from my switches to a central SNMP monitoring system so I did the basic enable snmp traps and defined a trap receiver address. The traps are received but the trap source is only the IP address which is rather painful and makes...

SNMP accees after 15.5.4.2-patch1.5 upgrade

Hi everybody! I've just upgraded XOS on my x480 switches to 15.5.4.2-patch1.5. After reboot I've noticed difference in config between old and new version. Old XOS configure snmpv3 add community XXXX name XXXX user v1v2c_rw configure snmpv3 add com...

What is the total POE budget for an X450a 48P switch

Maximum POE budget for X450A-48P Also where can you find the old data sheets

POE port_fault

Please advise if this is a software bug, but our x440-24p switch produced an error: POE port_fault and cause our access points to fail. To fix the issue the PoE had to be disable and re-enabled on the entire switch. However, the VoIP phones were no...

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN