ExtremeSwitching (EXOS/Switch Engine) - Page 670 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Netsight can not poll from switch behind firewall

I am using default SNMP setting, for local switch everything is going well but for remote site I can discover all switches using SNMP default setting but I can not poll any information. the connection between netsight and switches is over VPN and al...

Unpack .exe firmware XOS file

Hi, I have downloaded the firmware for a summit X430 and x440 and both are .exe files. I tried to uncompress with "standard" compressions tools but doesn't works, what kind of files are ? Thanks.

MLAG ports with a Untagged VLAN - Loop

Hi, Just would like to understand if you have an un-tagged vlan for example vlan default on your mlag ports on both switches will this create a loop."Yes vlan default is also on the ISC port between the switchs" Would this be like joying to access...

Black Diamond 8810; what is the command to show the layer 3 (inter vlan) switching utilization?

Hello. I want to know in a Black Diamond 8810 the Utilization of the Layer 3 traffic between the Vlan's. For the Physical interfaces the command to see the utilization is "show ports utilization". Is there also a command to see the same for the Vl...

SNMP trap with sysName parameter

I want to receive traps from my switches to a central SNMP monitoring system so I did the basic enable snmp traps and defined a trap receiver address. The traps are received but the trap source is only the IP address which is rather painful and makes...

Top Kudoed Authors

User

Count

33

29

22

20

17

GTM-P2G8KFN