I tried to post the solution to my question regarding setting up an ISC+MLAG configuration between two x590s and a 450-G2 stack. The comment was automatically flagged and removed as spam.I clicked the link "click here to contact the moderators if you...
Good afternoon,what will be a cause of the stacking port to failed, only one port of the node is down , stacking ring still up connectivity remains on the node, any commands to see what causes the error? just reboot the node? thanks
In my EOS switches if I SSH into them and a device plugs into the switch...I see a message that says "so and so port is active"...In EXOS I have to manually type the "show log" command and then scroll all the way back to the top to see the same type ...
hello everyone,We have an issue with some switch x450-48p and x440-24p.These switch when boot up did not load the primary configuration (that is previus saved), below the steps done:1)Boot up a switch that have factory default config2)change account ...
