ExtremeSwitching (EXOS/Switch Engine) - Page 680 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

How to Config MPLS to use with "Xconnect" (cisco)

Example of cisco command ################################################# interface Vlan1234 mtu 15xx xconnect xxx.xxx.xxx.xxx 1234567890 encapsulation mpls no shutdown ! Anybody have an idea to cfg Exos, and work with Cisco xcon...

ELRP and enable igmp snooping forward-mcrouter-only [VR ]

Have quick question If I enable: enable igmp snooping forward-mcrouter-only [VR ] does this affects also ELRP ? And ELRP packets will not be generated from the switch ? Thanks

one or two port of x440-poe switch go down and come up

one or two port of x440-poe switch go down and come up for no reason, this happens frequently on all X-440P switches ....... Below is the power usage: 18W out of 170W Firmware Status Power (Watts) Power (Watts) LegacyOperational ...

XOS ping with record-route

What is the use-case for an ping the option "with record-route" ? How can use it reasonable? Command line reference do not tell anything deeper. If i try it, i will get following output: Slot-1 cnsha1sw001.24 # ping vr "VR-Default" continuous 10....

X460G2 (Stack) - stack node crash

Today we had an crash of 1 node in a 2 node X460G2-48p-10G4 stacking configuration. things began to become unresponsive. After checking the chalet gui and checking true serial port i saw node 1 unresponsive. The error was with extremexos 15.7.1.4 an...

Top Kudoed Authors

User

Count

33

29

22

20

17

GTM-P2G8KFN