ExtremeSwitching (EXOS/Switch Engine) - Page 701 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

ExtremeXOS_Native_Application_SDK

Hello! Here is document http://extrcdn.extremenetworks.com/wp-content/uploads/2015/05/ExtremeXOS_Native_Application_SDK.pdf There described how we can write, compile, install and run native application on ExtremeOS. So, where can we download that ...

ELRP + UPM = Number of UPM Events in Queue for execution

Hello! I want to execute UPM after every LOOP detect without Queue. Now, I see couple of loops , but UPM executes with Queue. 07/22/2015 16:58:08.98 [CLI:v3000:4] LOOP DETECTED : 3241 transmited, 177 received, ingress slot:port (3) egress slot:po...

CLI command history

Hi, when entering the command history with arrow keys, I find that the CLI never returns back to a blank line but it sticks to the last command issued. It's annoying because to issue a new command you must first delete that command displayed. than...

log skips days

We have a x460-48p running 15.5.2.9 v1552b9-patch1-5. The switch rebooted after a System Failure. After it rebooted we looked at the log on the switch and it doesn't show any messages in the log for 6 days. Here is a little cut and paste. 7/28/...

Replacing MSM: Software incompatible

We replaced an MSM on a BD8810. When we first installed it, It upgraded firmware and then came online. We had though that it had just installed new firmware to the new card and it was working as expected. However, now I have noticed that it actually ...

Top Kudoed Authors

User

Count

33

29

22

20

17

GTM-P2G8KFN