ExtremeSwitching (EXOS/Switch Engine) - Page 763 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Share does not loadshare as it should

Hi Im creating a link aggregation with LACP between a X670V and a Ericsson SSR8000. The share contains 4 10Gb links and works fine except that it doesn't loadbalance over all 4 links. We have configured it to use L3-L4 as algorithm and the destinatio...

packet drop in port congestion monitor with multicast

Create Date: Apr 30 2012 4:21AM Hi I have bd8810 12.5.4.5. I noticed on port where i have only keepalived i see packets drop. I see port congestion on a few ports but this port is interesting because there is only keepalived. Normal traffic on ...

Using ACL to isolate all VLAN, only certain VLAN are allow to communicate.

Hi All, I have an situation, the requirement need us to isolate all VLAN, only allow certain VLAN communicate with each other. However, all VLAN shall able to go Internet. The challenge is there are OSPF in the network. Besides, there area VRRP con...

Upgrading XOS on 440-24p

Hi, I'm having some trouble connecting from my switch to my Laptop in order to perform a software upgrade. I can't ping outbound from the switch using PING VR VR-DEFAULT, I receive 100% loss. If I try to connect to a TFTP server using TFTP VR VR-DE...

STP: Changing the bridge priority of a switch

If I change the STP bridge priority of a switch to a lower value (from 20480 to 16384), using the command: config stpd s0 priority 16384, will that change take effect immediately? If not, do I need to restart stpd? disable stpd s0 enable stpd s0. ...

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN