ExtremeSwitching (EXOS/Switch Engine) - Page 764 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

H-VPLS interops with Juniper

I am trying to make the H-VPLS interops with Juniper router in a Hub and Spoke config where Spoke connects with two HuB. Full mesh VPLS is just working fine. We did some extensive tests and found that the HuB (Juniper) router DO NOT receive the la...

sflow/ipfix : "Src AS and DST AS implementation "

To fill our needs as opérator we would like to stats traffic by AS. So we successfully configure sflow and netflow on ExtremeXOS version 12.6.3.2. Unfortunatly packet does'nt show any information about AS. Is there an implementation of this fields i...

Concept guide 15.2

Where is the below document ? http://www.extremenetworks.com/wp-content/uploads/2014/03/EXOS_Concepts_Guide_15.2

How to log matched traffic in an ACL

The log keyword of an ACL doesn't seem to work, take this simple policy as an example: entry permit_ICMP { if { protocol icmp; } then { permit; mirror-cpu; log; count icmp; ...

Summit x450a after reset to factory default does not keep configuration

Hi, I have 2 summit x450a that after they were reset to factory default the switches started up with blank configuration as can be seen from the attached sample below and except for vlan that I was able to configure every other c...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN