ExtremeSwitching (EXOS/Switch Engine) - Page 781 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

How to install LegacyCLI-MOD

I am planning to install the LegacyCLI-MOD onto switches comfigured in a stack (2x X440, and 2x X450). I have backed up the config on the primary/master switch to a tftp server. Is there any other backup methods suggested, other than backing up the ...

Error: ACL install operation failed - slice hardware full for vlan *

Create Date: Jun 5 2013 7:20AM When i apply some ACL to interface it display this error condition, how to reset this status. (from Hsu_LiPing)

disable (remove) license from x460

I have an x460 that came as an Edge license, but I purchased a Core license and have enabled the purchased license. I want to RMA the switch because it doesn't work right and we've only had it for 2 months. The port link light on the switch don't l...

routing via interface on extreme 670, xos 15.3

Hi, On some linux server i have routing via interface: ifconfig eth0 10.10.20.1/24 route add -net 10.10.10.0/24 dev eth0 I'd like do the same on extreme 670, but i can't something like this: configure vlan999 ipaddress 10.10.20.1/24 configure ipr...

MLAG/ISC/Teaming-Bonding

Hello, we have Windows servers with that nifty Broadcom "Teaming" option as well as Linux CentOS servers with "Bonding" - and of course VMWare hosts with their virtual "switches". Now to set them up properly for both speed aggregation and/or redunda...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN