ExtremeSwitching (Other) - Page 122 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

Getting a wrong DSCP value while configuring QOS settings

Below is the config on my test environment. I am currently testing with NEC dTerm IP phones and C5K stacks. Trying to make sure QOS settings are correct and the voice packets have high priority. However, when I trace my packets, I keep getting the D...

Source Based Routing

I have multiple routes to a particular network, I would like to route a particular local network over a certain link, while the rest of the local networks to that remote network over the normal routes. Is there a source based routing solution I can ...

LoopProtect and MSTP

Hi, I've been reading up on Spanning Tree and LoopProtect. In the 7100 v8.41 Configuration Guide on page 338 there is a note that says: The Loop Protect enable/disable settings for an MSTI port should match those for the CIST port. What exactly doe...

2016-04-25: New GTAC Knowledge Articles April 17 - 23, 2016

Here are the new articles that were published April 17 - April 23, 2016 in GTAC Knowledge: Sunday, April 17, 2016: none Monday, April 18, 2016: Bad NVRAM message seen in K-Series logs How to disable a port on a non Extreme XOS device in OneView How...

2016-04-11: New GTAC Knowledge Articles April 3 - April 9, 2016

Apologizes that I have not been posting these the last few weeks. We are still working on some improvements to this process! If you find these lists of new articles useful, please let us know via comments here on the Hub and feedback on the articles....

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN