ExtremeSwitching (Other) - Page 135 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

Port channel with C3560 cisco switch

I need to setup a port channel with a Cisco switch. I just want to verify the steps I need to perform. This is what I have on the Cisco side for the port channel config so far: interface Port-channel1 description Etherchannel to summit ...

How can I correct a stack mac address

We have a stack of 1 x460 and 3 x440s running summitX-15.5.3.4-patch1-2.xos Over the weekend the building they are in lost power and apparently power was restored 1 phase at a time. Slot 4 has rebooted several additional times with the reason (no...

AP goes offline and requires switch reboot to come online.

We have all AP3605. Current firmware 09.12.01.0067. This has been happening with prior versions as well. They are connected to Enterasys B-Series switches (FW 06.81.01.0027) and occasionally, the AP will go offline with no lights, and I'm assuming no...

C5 switch - No other entries in ARP table besides host

Hello everyone, I'm new to Enterasys/Extreme Networks equipment in general but I come from a Cisco background. In all of the production C5 switches I have worked with so far at this site - when I do a "show arp" command, there is only the host entr...

2015-11-09: New GTAC Knowledge Articles November 1 - November 7, 2015

Here are the new articles that were published last week (November 01 - November 07 2015) in GTAC Knowledge: Sunday, November 01, 2015: IDM enabled port without logging in to the PC accounts the port as authenticated and assign a Kerberos authentica...

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN