Where should I configure IP address on switch for SNMP?
Simple one. After enabling snmp on the switch? Where should I configure IP address on switch ? I mean on VLAN/Loopback/Interface etc.?
Forum Posts
New GTAC Knowledge Articles July 26 - August 1, 2015
Here are the new articles that were published last week (July 26 - August 1, 2015) in GTAC Knowledge: Sunday July 26, 2015 Netsight install fails with Installer exiting with code: 127 Monday July 27, 2015 OSPF neighbor is in Init state Change in mi...
SNMP Receiver Not Able to Pull MAC Address and Other Info from BlackDiamond and Stacked Summit Switches
Hello Everyone, I am currently having an issue pulling device info from my Blackdiamond cores and stacked Summit series switches via SNMP (Both v2 and V3 produce same results). My non-stacked Summit series switches are not experiencing this issue a...
Extreme X670-48t share port 45-48(Copper or Fiber)
Hi , Please advice, After Stacking 2 Switches X670-48t with both switches port 47-48 with Extreme 10306 SFP+ Cable. My switch port 45 and 46 not able to working with copper connected with port 45 and 46. Attach some config photo .
New GTAC Knowledge Articles July 20-25, 2015
Here are the new articles that were published last week (July 20 - July 25, 2015) in GTAC Knowledge: Monday July 20, 2015: none Tuesday July 21, 2015: K-Series fabric module will not fully boot with debug log message: failed to initialize PHY hard...
