This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
Help
ExtremeSwitching (Other)
Questions and discussions about switching in general
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Start a conversation

Stack 1 Backup/Stack 2 Master Flip-Flop

So last night we had stack 1 of our 3 switch stack go down due to a UPS problem. Fail-over occurred perfectly and stack 2 became the master. Once we fixed the UPS, the stack 1 switch came back up without a problem. Now stack 2 is the master and st...

Upload configuration to stacked x400

I am looking to convert a standalone x400 to a stacked x400. I saved the downloaded the configuration from the standalone x400. Can I just enable stacking and then re-upload the same configuration to get that switch back in the same config, just with...

Uploading config to already working stack....

I am new to stacking; But, a master node of the stack went down this week. It was replaced enough to get it working with most of the config present but not all. Remotely I have been tasked with uploading a backed up known working config. Do I nee...

Jimmy2 by • New Contributor
  • 1701 Views
  • 4 replies
  • 0 kudos

Communication between 2 Vlans

I am trying to get our wireless network communicating with a specific Vlan. So our wireless network is setup with a vlan as well. I have ipforwarding enabled for both vlans. What am I missing? Just a little more information: If I am connected to ...

Module on Matrix X 16 CPU load 100%

Hello guys, We have a Matrix X 16-slot. On one of the modules we received the following messages: WARNING: CPU utilization (100.0%) has exceeded the monitored threshold limit (80.0%) After that all the ports on the module stopped working. The module...

GTM-P2G8KFN