ExtremeSwitching (Other) - Page 162 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

OpenSSL 3.0 Threats a.k.a POODLE

VN-2014-003- Poodle - OpenSSL 3.0 Threat -CVE-2014-3566 What about the 800series - that one isn't listed. IdentiFi Wireless - target release is 9.12.04 & 8.32.12 - both are out already but I don't see any information in the release notes that the b...

LSNAT on S Series

Hi there, Does anyone have a configuration example for using LSNAT on the S Series with source-NAT? I'm happy with how load balancing works without NAT, but now have a requirement to use source-NAT to hide the clients behind. The feature guide is ...

Configuration Netflow in S-Series does NOT Work

This is the configuration of my S-Series, however my collector receives no information, I do not understand what the problem is. I monitor the collector with "tcpdump port 2203" but nothing is received, however if from the S-Series run telnet to 2203...

Problem with Matrix E1 and Cisco 3905 using ciscocdp

Hi!!! I have a problem with ciscocdp on matrix E1. I have a C5 and all is working fine. The same configuration has been configured on E1 series but the cisco 3905 does not get the voice vlan configure on the vvid parameter. I know that the device is...

Enterasys S8 Flapping ports

We're observing a higher-than-desired number of "bad" ethernet port > negotiations. On Two ports of this Switch , I ve tried all posible combinations of ( duplex , negocitation speed etc) in both sides, but these ports continues up/down. These po...

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN