ExtremeSwitching (Other) - Page 168 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

link aggregation, two links, two streams, yet only single bandwidth

The setup is simple: There's a backup server using HP Teaming software to form a LAG of two gigabit copper ports with a 7100 using LACP. Establishment of the lag works fine and the aggregate bandwidth is shown correctly as 2Gbps. Now I know what a si...

port shows as forwarding even when disabled

On 7100 v8.22 I see the following: ->show port status ge.2.3-4 Port Alias Oper Admin Speed Duplex Type (truncated) Status Status (bps) ------------ ---------------- -------- ------- ------ ------- ---...

DHCP snooping question and clearing routes

On Extremeware, v7.8 (platform doesnt matter but lets call it a 7i), where is the DHCP snooping command? Is DHCP snooping possible on extremeware? And, on XOS, how do we clear the OSPF routing table? On Cisco it would be I believe clear ip rotute ...

Simple .. perhaps stupid NAT and Routing Questions

sorry .. for (perhaps) stupid questions .. but until now i never needed Routing an NAT . We are a little public School in germany and into the last 15 years we had a pure public Network, every printserver had a public address because we have a full ...

KVA switches Extreme

I have to enter 1 switch X460-24t and 1 switchX430-24t to a Data Center, ask me a value of KVA, could someone tell me what these values for these switches, some documentation where find this. regards

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN