ExtremeWireless - V10.21 Reports gone new reports

[JohanHendrikx]

After upgrading V2110 with firmware 10.21.01.0065 I noticed its was not possible to see the clients per VNS or AP. It too bad because I used that report a lot.

There is also a new one: 'Channell Inspector'. Verry userfull, But isn't Overlap/Interfering the same as Adjacent ?

[Steve_Ballantyn]

Here is a Me-Too in your direction.

I created a ticket earlier this week with product enhancement requests. This was request #1 on my list (please give the the old Client reports back). I too had grown pretty accustomed to using it.

For me - it was a quick way to check and see if any one particular access point was handling too much of the load.

[Gareth_Mitchell]

Thanks Ron, I have documented this in the knowledge-base: https://gtacknowledge.extremenetworks.com/articles/Q_A/How-do-I-access-the-Active-Clients-by-Wireles...

-Gareth

[Steve_Ballantyn]

Hey, that's what I was looking for! Thanks for the tip Ron.

[JohanHendrikx]

That is top. So this helps me a lot.

Thanks Ronald

[Ronald_Dvorak]

I just had an idea and gave it a try.... go to the controller dashboard and click on the "station by AP" section and you get the "old" clients by AP report - CR solved 🙂